Another rotor order completed
We’ve completed and shipped another rotor batch for plastering machines, covering three models — SD6-3, D7-2.5 and D6-3. Each was produced to drawing and prepared for delivery to a customer abroad.
Checked before packing
Rotors are consumable parts: when one fails, the machine stops. That’s why every rotor in this batch went through our standard checks before packing — geometry verified against the drawing, metal hardness tested, and surface finish inspected. The goal is a predictable service life, batch after batch.
Packed for long-distance transport
Once checked, the rotors were layered and protected inside wooden crates built for long-distance transport. Every batch ships from our European base with a material certificate for the lot and full accompanying documentation.
Models and compatibility
The models in this order — SD6-3, D7-2.5 and D6-3 — are part of our standard rotor and stator range, compatible with common plastering machines. For older or rare equipment, we also produce non-standard pairs by drawing or sample. You can see the full range on our [Rotors & Stators catalogue page] and learn more about our [quality control process].
Need rotors for your machines?
If you’re sourcing rotors or stators for plastering machines, contact us or visit rotors.tech — we’ll share the full catalogue and available models.
